DIY repair · Ford Bronco (1966–1977)

Vacuum wipers to electric (1966–69)

DIFFICULTY 2 / 5TIME ≈ Half a dayCOST Parts plus your time

Symptoms

Wipers that slow down or stop when you accelerate uphill, the classic vacuum-wiper failure, or a vacuum-wiper fuel pump blocking a power-steering pump.

The fix, step by step

  1. Ford switched from vacuum to electric wipers in mid-1969, and on the early trucks the vacuum supply runs through the fuel pump.
  2. Remove the vacuum motor and its lines, fit the electric motor and bracket on the windshield frame, connect the motor arm to the existing linkage and run the wiper harness to a switch.
  3. An electric-wiper cover finishes the job.
  4. Replace the fuel pump with a non-vacuum V8 pump while you're there, which also frees up the spot a power-steering pump needs.

Tools & part numbers

  • Screwdrivers and sockets
  • drill
  • wire strippers and crimpers
  • test light

Where to buy the parts

1966–77 Bronco electric wiper motorBronco Graveyard ↗Amazon ↗
1969–77 Bronco wiper motor wiring harnessBronco Graveyard ↗Amazon ↗
Wiper linkage motor arm for electric wipers, 1966–77Bronco Graveyard ↗Amazon ↗
1966–77 Bronco V8 fuel pump (289/302/351W)Bronco Graveyard ↗Amazon ↗

Hunting a used or discontinued part? Search eBay Motors for Ford Bronco (1966–1977) parts →

Before you start

Rated for a competent home mechanic with a decent tool kit. Confirm torque figures, fluids and procedures against the factory service manual for your VIN, support the truck on stands rather than a jack, and work at your own risk (disclaimer). Some parts links are affiliate links, which pay us a small commission at no cost to you.

The Boxy Dispatch · monthly

One new guide, one featured rig, one recall worth knowing. Monthly, no spam.

Subscribe and get a free printable inspection checklist for any truck we cover.